News

The Forming Process Principle Of Castings

Feb 16, 2026 Leave a message

Castings (also known as castings) involve pouring molten metal into a sand mold, metal mold, or ceramic mold cavity under gravity or low pressure, allowing the metal to fill the cavity through its own weight or low pressure (typically ≤0.15MPa). Taking sand casting as an example, a sand mold must first be made. The molten metal flows slowly into the cavity through a pouring cup, and the solidification time is relatively long (from several minutes to several hours). For example, in the casting of large machine tool beds, the sand mold needs to allow for shrinkage (typically 1.5%-2%) to compensate for the metal's solidification shrinkage.

 

Castings, due to their slow solidification rate, have a coarser metal structure (ASTM grain size grade 3-5), a surface roughness typically Ra 6.3-25μm, and dimensional accuracy IT14-IT16. However, they are free of porosity defects and have better uniformity in mechanical properties. For example, wind turbine gearbox housing castings can have wall thicknesses exceeding 50mm and can withstand alternating loads.

Send Inquiry